Intarsia process of computerized flat knitting machine
Manual intarsia flat knitting machines have added intarsia knitting function. The triangular adjustment and the working state of the needle latch are completely different from those of ordinary flat knitting machines.
1. Computer control The flat knitting machine of intarsia can be a special flat knitting machine for computer intarsia, or it can be a general computer jacquard flat knitting machine. Generally, computer-controlled flat knitting machines have the function of single-needle selection. If the principle of controlling the displacement of the yarn guide is adopted, intarsia fabrics with various patterns can be knitted efficiently.
2. The weaving principle of intarsia fabrics on a general computerized flat knitting machine Since each course is woven by a set of yarn carriers corresponding to the color blocks, intarsia requires a special device. The traditional V-type intarsia flat knitting machine needs to be equipped with a complex yarn guide positioning system, which will be moved to a new position after every few courses knitted, which requires stopping at the edge of the color block that changes according to the pattern and Rearrange the yarn guides.
3. The new computerized flat knitting machine is controlled by the computer signal to control the pin of the yarn guide, which can drive or put down each yarn guide at any place of the knitting width. It does not need a special positioning block to weave intarsia products, but in order to weave more effectively For complex intarsia weave, most computerized flat knitting machines also need to be equipped with a special intarsia yarn guide, which can not only accurately place the yarn on the selected needle, but also control the yarn guide. Swing left and right to exit work.
4. In intarsia knitting, when a certain yarn guide finishes knitting a certain color area, in order not to raise the needles of the next color area and hook the yarn of this yarn guide, you can make this yarn guide. The yarn feeder swings an angle according to the program requirements.
Leave a comment